engine oil HONDA FIT 2013 3.G Technology Reference Guide

Malfunction IndicatorsIf an indicator remains on, there may be a problem; see your dealer
On/Off Indicators
Condition IndicatorsAction is needed by driver
PASSENGERAIRBAG
OFFPASSENGER AIRBAG OFF(located on center panel)
SIDE AIRBAGOFF
CRUISE CONTROL on
VSAOFF
Fog lights on*
Headlights on
Turn signals/hazards on
High beamson
Charging system
Low brake fluid
Low oil pressure
ABS(anti\block brake system)
DRL(daytime running lights)
Malfunction lamp(check engine light)
VSA®(vehicle stability assist)SRS(supplemental restraint system)
Low temperature
EPS(electronic power steering)
TPMS(tire pressure monitoring system)
DTransmission*(blinking)
Parking brake on:
Release
Door/Tailgate open:
Close door(s)/tailgate
Maintenance MinderTM:
Make dealer appointment
Low fuel:
Refill
* automatic transmission
*Sport model only
High temperature:
Slow down or pull over
Low tire pressure:
\fdd air
INSTRUMENT PANEL INDICATORS
Immobilizer
Flashes: improperly coded key;
use correct key
Briefly appear with each engine start. Red and amber indicators are most critical.
Blue and green indicators are used for general information.
45
CRUISE MAIN on
Seat belt reminder:
Fasten seat belt(s)
Automatic transmission model shown
13 Fit TRG\fATG_NEW STYLE 5/30/2012 4\f54 PM Page 4

Accessing the Information Display
Information Displays
I N F O R M A T I O N D I S P L A Y
Consists of several displays that provide you with useful information.
\b
Instant fuel
economy,
OdometerInstant fuel
economy,
Trip meter
Oil life
7
Instant and
average fuel
economy
What to Do
How It Works
TIRE PRESSURE MONITORING SYSTEM (TPMS)
Monitors the vehicle’s tire pressures.
Each tire valve stem contains
a TPMS sensor.
When the tire pressure drops
significantly below recommended
levels, the low tire pressure
indicator comes on.
If the TPMS indicator appears, there
may be a problem with the system.
See your dealer.
\f. Visually inspect the tires for
damage.
2. Use a tire air pressure gauge to
check which tire(s) have low
pressure.
3. Inflate the tire(s), if necessary,
to the recommended pressures
listed on the label on the
driver’s doorjamb.
To toggle between the different
displays, press and release the
select/reset knob repeatedly.When you start the engine, the
display shows your last active
selection from the previous drive
cycle.
13 Fit TRG\fATG_NEW STYLE 5/30/2012 4\f55 PM Page 5